%30 indirimli
Stokta Yok

Cytron SmartDriveDuo-60

Ürün Kodu : 15869
Barkod : Marka :
3.619,58 TL + KDV
5.170,83 TL + KDV
Paylaş:
Kampanya
  • Ürün Özellikleri
  • Yorumlar (0)
  • Teslimat Koşulları
  • Tavsiye Et
  • Finally, it is ready! The smart drive duo-channel 60Amp driver is here! After Cytron's 1st 10Amp smart drive, now we introduce the 60Amp version! It supports dual channels, 60A continuous current for each channel. Building combat/sumo robot become easy, choose motor+wheel, get high power battery, thick wire, connect it to MDDS60, choose a RC controller and you have a robot !! Do check the User's Manual for details. Quick Start Guide is here.
     
    With knowledge and feedback we gathered from MD10CMDD10AMD30CMDS40AMDDS10 and MDS160A, we are thrilled to launch this smart motor driver and can't wait to see what you can do with it.
     
    * Do use proper wire/cable for battery and motor connection. Think jumper wire/cable cannot support high current application. We recommend using AWG8 Red and Black multicore wire.
     
    Features:
    • DC Brush motor Driver, not for brushless motor
    • Input Voltage (Motor): 7 - 45VDC
    • Single power operation, just connect power to battery input.
    • Dual Channels, it can drives two brush motor independently, or mixed.
    • Operating modes: RC (RC servo signal), Analog, PWM, simplified and packetized UART.
    • Support Signed magnitude and Locked Anti-phase in PWM mode.
    • Top cover comes with two DC brushless fans to cool the driver.
    • Two manual/test buttons for each channel.
    • Two output indicator LEDs for each channel.
    • Power, Error indicator, RUN status (Left and Right) LEDs
    • On board reset button to restart the MCU after changing operation mode.
    • Temperature feedback for current limit and prevent overheating of MOSFET.
    • Support up to 60A continuous current at room temperature.
    • Support up to 100A peak for 1 second. Current will be limited as temperature raises.
    • Suitable for combat or sumo robot.
    • 16KHz switching frequency for quiet operation.
    • On board switching voltage regulator for higher power efficiency.
    • Battery low voltage monitoring mode.
    • We have tried this driver with single power window motor at 24V, full load without smoke coming out :)
    • NO polarity protection, please double check the power input connection.
    • Do use proper cable/wire for the battery and load, thin/normal cable/wire will melt and burn.
    • Dimension: ~190mm x 121mm x 45mm.
T-Soft E-Ticaret Sistemleriyle Hazırlanmıştır.